Bork Dalrymple (trailhat40)

d to an ICU; 15.5% of those admitted in ICU have no other SAMM criterion and a less acute condition. These results challenge the use of ICU admission as a criterion of SAMM.In this paper, magnetic cotton textile wastes pyrolyzed by ferric cerium oxide (FexCey oxide/PC) were synthesized for degradation of p-nitrophenol by catalytic ozonation, and the optimal Fe-Ce ratio was 101. Compared to Fe10Ce1 oxide, the Fe10Ce1 oxide/PC not only greatly improved the degradation efficiency of PNP, but also reduced the dosage of catalyst. Through the BET test, the Fe10Ce1 oxide/PC has a high specific surface area to absorb part of the pollutants. VSM test shows that the material is magnetic and easy to recycle. Response surface methodology (RSM) was applied to optimize the experimental condition, and the optimal removal rate was 90% when the initial pH was 9, the catalyst dosage was 0.4 g/L, and the ozone addition was 1.77 L/min (5.9 mg/L). Finally, the mechanism of PNP degradation was explored utilizing inhibitor and ESR free radical detection. The adsorption capacity of the material and electron-absorbing property of PNP jointly determined the high catalytic efficiency with Fe10Ce1 oxide/PC in catalytic ozonation.The environmental release of mercury is continuously increasing with high degree of mobility, transformation and amplified toxicity. Improving remediation strategies is becoming increasingly important to achieve more stringent environmental safety standards. This study develops a laboratory-scale reactor for bioremediation of aqueous mercury using a biofilm-producing bacterial strain, KBH10, isolated from mercury-polluted soil. The strain was found resistant to 80 mg/L of HgCl2 and identified as Bacillus nealsonii via 16S rRNA gene sequence analysis. The strain KBH10 was characterized for optimum growth parameters and its mercury biotransformation potential was validated through mercuric reductase assay. A packed-bed column bioreactor was designed for biofilm-mediated mercury removal from artificially contaminated water and residual mercury was estimated. Strain KBH10 could grow at a range of temperature (20-50 °C) and pH (6.0-9.0) with optimum temperature established at 30 °C and pH 7.0. The optimum mercuric reductase activity (77.8 ± 1.7 U/mg) was reported at 30 °C and was stable at a temperature range of 20-50 °C. The residual mercury analysis of artificially contaminated water indicated 60.6 ± 1.5% reduction in mercury content within 5 h of exposure. This regenerative process of biofilm-mediated mercury removal in a packed-bed column bioreactor can provide new insight into its potential use in mercury bioremediation.In the present research, the removal of Basic Orange 2 (BO2) dye using alkaline-modified clay nanoparticles was studied. To characterize the adsorbent, XRD, FTIR, FESEM, EDX, BET and BJH analyses were performed. Torin 1 clinical trial The effect of the variables influencing the dye adsorption process such as adsorbent dose, contact time, pH, stirring rate, temperature, and initial dye concentration was investigated. Furthermore, the high efficiency of Ni2+ removal indicated that it is possible to remove both dye and metal cation under the same optimum conditions. The experimental data were analyzed by Langmuir and Freundlich isotherm models. Fitting the experimental data to Langmuir isotherm indicated that the monolayer adsorption of dye occurred at homogeneous sites. Experimental data were also analyzed with pseudo-first-order, pseudo-second-order, and intra-particle diffusion kinetic equations for kinetic modeling of the dye removal process. The adsorption results indicated that the process follows a pseudo-second-order kinetic model. The thermodynamic parameters of the dye adsorption process such as enthalpy, entropy, and Gibbs free energy changes were calculated and revealed that the adsorption process was spontaneous and endothermic in nature. The results presented the high potential of the modified nanoc