Williamson Husted (ronaldfield7)

Separation of slurries can facilitate the nutrient management on farms through nutrient partitioning between the liquid and the solid fraction. The distribution of nutrients in the slurry fractions depends largely on the type of separator used. The current study assessed the separation efficiency of a two-step separation treatment of pig slurry including in-series a screw press and a centrifuge followed by acidification (to pH 5.9) of the final liquid effluent. The system concentrated 73.8% of the slurry's Phosphorus (P) content, 52.6% of Total solids (TS) and 14.4% of total Nitrogen to the solid fraction. The apparent N recovery from ryegrass fertilized with the raw slurry and non-acidified liquid fractions was not decreased by the separation treatment. The acidified liquid fraction showed 28% and 9% higher apparent N recovery compared to the raw slurry and the non-acidified liquid effluent from the centrifuge respectively. The biochemical methane production potential (Bo) of the acidified liquid fraction was reduced by 50% and 25%, compared to the non-acidified counterpart and the raw slurry, respectively. The results highlight the potential of a double separation system coupled with acidification of the liquid fraction, to extract P into a solid fraction which can be transported outside the farm, and to increase N utilization from the liquid fraction when this is used as organic fertiliser on or nearby the farm. The study further highlights the potential to reduce CH4 emissions from slurry storage after mechanical separation and acidification of the liquid slurry fraction.Nitrous oxide (N2O) generated from wastewater treatment plants (WWTPs) has drawn attention due to its high emission load and significant greenhouse effect. In the present study, N2O emissions from a pilot-scale Carrousel oxidation ditch under various chemical oxygen demand (COD) to nitrogen ratio (COD/N) and aeration rates were systematically investigated. The highest N2O emission factor was 0.142 ± 0.013%, at COD/N of 5 and aeration rate of 1.8 m3 h-1, which was much lower than the majority of previous studies. The results could be attributed to the high internal recycle ratio of the oxidation ditch process which lightened the burden of influent load to the system. The profiles of N2O emissions and dissolved N2O concentration along the channels showed a distinct spatial variation that N2O emissions primarily occurred in the aeration zones due to the air stripping effect. However, both the aeration and anoxic zones contributed to N2O generation due to autotrophic nitrification (AN), which was considered to be the main N2O generation process. In addition, two simulated shock-load conditions, ammonia overload shock and aeration failure shock, were carried out to explore the response of the biological nitrogen removal (BNR) system. The results indicated that both shock-loads lead to excessive N2O emissions, especially at higher aeration rates, which could be explained by the improved N2O generation by AN process during the shock-load period. This study offered new insights into the role of operational parameters to N2O emission and the alternative approach for N2O mitigation during both the steady-state operation and shock-load conditions in the oxidation ditch process.Phosphorus (P) concentration beyond threshold limit can trigger eutrophication in stagnant water bodies nevertheless it is an indispensable macronutrient for aquatic life. Even in low P concentration (≤1 mg L-1), P can be detrimental for ecosystem's health, but this aspect has not been thoroughly investigated. The elimination of low P content is rather expensive or complex. Therefore, a unique and sustainable approach has been proposed in which valorized bivalve seashells can be used for the removal of low P content. Initially, acicular shaped aragonite particles (~21 μm) with an aspect ratio of around 21 have been synthesized through the wet carbonation process and used to treat aqueous solu