Petty Steensen (paultwig8)

Moreover, membrane-thinning effects and induced membrane curvature were displayed upon CPP interaction. Our results demonstrate that the impact exerted by the CPP on the membrane is notably affected by positioning and especially the degree of lipidation, which might influence the properties of CPPs as functional excipients.Defect structure is one of the crucial factors for enhancing the catalytic activities of photocatalysts. However, rational design and construction of defect structures in catalysts to meet the aim of enhancing photocatalytic performance in a simple and cost-effective way is still a challenge. In this contribution, we report a strategy to construct defect structures in graphitic carbon nitride (g-CN) by simple copolymerizing of urea with polyethyleneimine (PEI). Among the prepared catalysts, u-0.05PEI presents the best photocatalytic activity for CO2 reduction, with CO and CH4 yields of 32.86 and 1.68 μmol g-1 in 4 h, which is about 3.2 and 2.5 times higher than that of g-CN, respectively. Characterization results show that both C and N defects are formed in the newly prepared catalysts. The C defects on the surface of u-xPEI result in the formation of more amino groups which are beneficial for CO2 adsorption. Meanwhile, the N defects inside the samples lead to the generation of midgap states between the valance band and conduction band of u-xPEI. The midgap states greatly enlarge the light absorption extent, and enable the use of light with energy lower than the intrinsic absorption of g-CN in the photoreduction of CO2. As confirmed by DRS, EPR, PL analysis, the excellent catalytic activity of u-0.05PEI is mainly attributed to the remarkably improved light utilization efficiency and fast charge transfer. Moreover, the reaction is performed in water without any additive or organic solvent, which makes it environmentally friendly.Frequent outbreaks of emerging infectious diseases (EIDs) make personal protective filter media in high demand. read more Electrospun nanofibrous materials are proved to be very effective in resisting virus-containing fine particles owing to their small fiber diameters; however, hindered by the intrinsic close-packing character of fine fibers, electrospun filters suffer from a relatively high air resistance, thereby poor breathing comfort. Here, we report a biomimetic and one-step strategy to create ultrafine and curly wool-like nanofibers, named nano-wool, which exhibit fluffy assembly architecture and powerful electret effect. By achieving the online self-crimp and in-situ charging of nanofibers, the curly electret nano-wool shows a small diameter of ~0.6 μm (two orders of magnitude lower than natural wool ~20 μm) and an ultrahigh porosity of 98.7% simultaneously, together with an ultrahigh surface potential of 13260 V (one order of magnitude higher than previous filters). The structural advantages and powerful electret effect enable nano-wool to show excellent filtration efficacy (>99.995% for PM0.3) and low air resistance (55 Pa). Additionally, nano-wool can be easily scaled up, not only holding great industrial prospect in personal protective respirators, but also paving the way for developing next-generation wool in a cost-efficient and multifunctional form.Development of cost-effective and efficient earth-abundant catalysts for hydrogen evolution reaction (HER) is a great challenge. In this study, by one-step potentiostatic electrodeposition, the Ni-Se-Cu electrocatalyst on nickel foam was fabricated as a binder-free HER electrocatalyst. As compared with Ni-Se electrocatalysts, such fabricated Ni-Se-Cu electrocatalyst exhibited prominent electrocatalytic activity to the HER in alkaline electrolyte. This Ni-Se-Cu electrocatalyst exhibits a small overpotential of 136 mV to achieve a current density of 10 mA·cm-2 and high electrochemical stability. The remarkable HER properties of Ni-Se-Cu electrocatalyst mainly originate from high electronic conductivity induced by Cu-dopi