Bradley Kelleher (palmpansy8)

More than 40% of the total dry NH3 deposition occurred when air masses were traced back to agricultural source regions. More generally, we identified that 10 (25) more national parks in the U.S. are within 100 (200) km of an NH3 hotspot, and more observations are needed to quantify the impacts of these hotspots on dry NH3 deposition in these regions.A new porous copper-organic framework assembled from 12-nuclear [Cu12] nanocages [Cu2(L4-)(H2O)2]·4DMA·2H2On (1) (H4L = 5,5'-(butane-1,4-diyl)-bis(oxy)-diisophthalic acid) was successfully prepared and structurally characterized. Compound 1 feathering of a 3D framework with two types of 1D nanotubular channels and a large specific surface area can effectively enrich various harmful dyes. Additionally, due to the carbon dioxide (CO2) interactions with open Cu(II) sites and the electron-rich ether oxygen atoms of ligand in 1, it exhibits a highly selective CO2 uptake. Interestingly, 1 can effectively catalyze the cycloaddition reaction of CO2 with various epoxides under mild conditions, which is ascribed to the Lewis acid Cu(II) sites in the framework of 1. Importantly, 1 acting as a heterogeneous catalyst can be recycled at least 10 times without an obvious loss of catalytic activity, and the CO2 cycloaddition mechanism was further uncovered by density functional theory (DFT) calculations. This study can greatly enrich the MOF catalysts system of CO2 conversion and also provide a valuable guidance for the design of efficient MOFs catalysts.Scanning electrochemical microscopy (SECM) is a powerful tool for mapping surface reactivity. Electrochemical mapping of electrocatalytic processes at the nanoscale is, however, challenging because the surface of a nanoelectrode tip is easily fouled by impurities and/or deactivated by products and intermediates of innersphere surface reactions. To overcome this difficulty, we introduce new types of SECM nanotips based on bimolecular electron transfer between the dissolved electroactive species and a redox mediator attached to the surface of a carbon nanoelectrode. A tris(2,2'-bipyridine)ruthenium complex, Ru(bpy)3, that undergoes reversible oxidation/reduction reactions at both positive and negative potentials was used to prepare the SECM nanoprobes for mapping a wide range of electrocatalytic processes through oxidation of H2, reduction of O2, and both oxidation and reduction of H2O2 at the tip. In addition to high-resolution reactivity mapping and localized kinetic measurements, chemically modified nanoelectrodes can serve as nanosensors for a number of important analytes such as reactive oxygen and nitrogen species and neurotransmitters.The O6-alkylguanosine adduct O6-carboxymethyldeoxyguanosine (O6-CMdG) has been detected at elevated levels in blood and tissue samples from colorectal cancer patients and from healthy volunteers after consuming red meat. The diazo compound l-azaserine leads to the formation of O6-CMdG as well as the corresponding methyl adduct O6-methyldeoxyguanosine (O6-MedG) in cells and is therefore in wide use as a chemical probe in cellular studies concerning DNA damage and mutation. However, there remain knowledge gaps concerning the chemical basis of DNA adduct formation by l-azaserine. To characterize O6-CMdG formation by l-azaserine, we carried out a combination of chemical and enzymatic stability and reactivity studies supported by liquid chromatography tandem mass spectrometry for the simultaneous quantification of O6-CMdG and O6-MedG. We found that l-azaserine is stable under physiological and alkaline conditions as well as in active biological matrices but undergoes acid-catalyzed hydrolysis. We show, for the first time, that l-azaserine reacts directly with guanosine (dG) and oligonucleotides to form an O6-serine-CMdG (O6-Ser-CMdG) adduct. Moreover, by characterizing the reaction of dG with l-azaserine, we demonstrate that O6-Ser-CMdG forms as an intermediate that spontaneously decomposes to form O6-CMdG. Finally