Walker Lauridsen (outputwhale92)

PURPOSE Different titanium bases for implant-supported prostheses can present different mechanical behavior. The goal of this study was to evaluate the torque before and after fatigue, the load to failure, and stress concentration of zirconia restorations cemented or notched to a titanium base. MATERIALS AND METHODS Forty implants were included in polyurethane cylinders and divided into two groups zirconia restoration cemented on a titanium base and zirconia restoration notched on a titanium base. selleck chemical The specimens had their torque loosening and vertical misfit evaluated before and after cyclic fatigue (200 N/2 Hz/2 × 106 cycles/37°C). Load to failure was evaluated in a universal testing machine (1 mm/min, 1,000 kgf). Failures were evaluated by scanning electron microscopy. Three-dimensional models were created, and the stress concentration was calculated using the finite element method. Data from the in vitro tests were submitted to two-way analysis of variance and Tukey test (α = .5). RESULTS The cemented restorations presented less torque loosening (19.79 to 15.95 Ncm), lower vertical misfit (3.7 to 10.5 μm), lower stress concentration in the restoration (88.2 to 99.8 MPa), and higher fracture load (451.3 to 390.8 N) than notched restorations. CONCLUSION The presence of a cement layer between the restoration and titanium base reduced the susceptibility to abutment screw loosening, improved the resistance to compressive load, and reduced the stress concentration in the restoration.PURPOSE To evaluate the dimensional variations after elevation of the maxillary sinus floor and the healing of the antrostomy left unprotected or protected by a collagen membrane. MATERIALS AND METHODS Twenty patients were included in the study. After the elevation of the sinus mucosa, natural bovine bone was grafted into the elevated space. In 10 randomly selected patients, a native collagen membrane made of porcine corium was placed on the antrostomy (membrane group). In the other 10 patients, the antrostomy was left uncovered (no-membrane group). Cone beam computed tomography (CBCT) images were taken for all patients before surgery (T0), 1 week after sinus floor augmentation (T1), and after 9 months of healing (T2), and evaluations of dimensional variations over time of soft and hard tissues were performed. RESULTS At T1, the elevation of the sinus floor in the middle aspect was 12.5 ± 3.8 mm and 11.9 ± 3.6 mm in the membrane and no-membrane groups, respectively. At T2, the reduction in height of the elevated space was 0.6 ± 0.9 mm and 0.8 ± 0.8 mm in the membrane and no-membrane groups, respectively. The elevated area decreased between ~10% and 11% in the membrane group and between ~15% to 20% in the no-membrane group. However, no statistically significant differences were found. CONCLUSION The use of a collagen membrane to cover the antrostomy after sinus floor elevation did not produce significant clinical effects on dimensional variations over time.PURPOSE To evaluate the effect of continuous tooth eruption on the outcomes of single-implant-supported restorations in the anterior maxilla of adults. MATERIALS AND METHODS Seventy-six patients (age 21 to 78 years) treated with single-implant-supported restorations in the esthetic zone were included. Radiographs obtained at crown placement and follow-up examinations from 1 to 15 years postloading were analyzed with regard to vertical incisal plane changes of the implant-supported crown relative to adjacent teeth. RESULTS Infraocclusion increased over time by 0.08 ± 0.02 mm/year. Infraocclusion was more pronounced (P = .04) for delayed (0.09 mm/year) versus immediate implant placement (0.06 mm/year) and for younger versus older adults (0.0013 mm/year per additional year of age; P = .014). No statistically significant association between infraocclusion and sex, ethnicity, implant site, timing of implant temporization, surgical protocol, and type of restoration was found. CONCLUSION