McGrath Overgaard (forestcouch04)

Introduction The number of patients with iatrogenic spinal deformities is increasing due to the increase in instrumented spinal surgeries globally. Correcting a deformity could be challenging due to the complex anatomical and geometrical irregularities caused by previous surgeries and spine degeneration. Virtual and 3D printed models have the potential to illuminate the unique and complex anatomical-geometrical problems found in these patients. Case Presentation We present a case report with 6-months follow-up (FU) of a 71 year old female patient with severe sagittal and coronal malalignment due to repetitive discectomy, decompression, laminectomy, and stabilization surgeries over the last 39 years. The patient suffered from severe low back pain (VAS = 9, ODI = 80). Deformity correction by performing asymmetric 3-column pedicle subtraction osteotomy (PSO) and stabilization were decided as the required surgical treatment. Olitigaltin cell line To better understand the complex anatomical condition, a patient-specific virtual geometrered advantageous by the surgical team in the pre-surgical phase and during the surgery as well. The model was able to simplify the geometrical problems and potentially improve the outcome of the surgery by preventing complications and reducing surgical time.Introduction Africa has many untreated neurosurgical cases due to limited access to safe, affordable, and timely care. In this study, we surveyed young African neurosurgeons and trainees to identify challenges to training and practice. Methods African trainees and residents were surveyed online by the Young Neurosurgeons Forum from April 25th to November 30th, 2018. The survey link was distributed via social media platforms and through professional society mailing lists. Univariate and bivariate data analyses were run and a P-value less then 0.05 was considered to be statistically significant. Results 112 respondents from 20 countries participated in this study. 98 (87.5%) were male, 63 (56.3%) were from sub-Saharan Africa, and 52 (46.4%) were residents. 39 (34.8%) had regular journal club sessions at their hospital, 100 (89.3%) did not have access to cadaver dissection labs, and 62 (55.4%) had never attended a WFNS-endorsed conference. 67.0% of respondents reported limited research opportunities and 58.9% reported limited education opportunities. Lack of mentorship (P = 0.023, Phi = 0.26), lack of access to journals (P = 0.002, Phi = 0.332), and limited access to conferences (P = 0.019, Phi = 0.369) were associated with the country income category. Conclusion This survey identified barriers to education, research, and practice among African trainees and young neurosurgeons. The findings of this study should inform future initiatives aimed at reducing the barriers faced by this group.The pathophysiology of Horner's syndrome arises due to compression or destruction of the oculosympathetic nerve pathway. Traumatic Horner's syndrome may indicate lethal neurovascular injury, such as brain stem lesion, cervical spine injury, or carotid artery dissection. The middle-third is the most common type of clavicle fracture. However, the association of the isolated middle-third clavicle fracture and Horner's syndrome is rare. We report the case of a 47 year-old woman who presented to our emergency department with acute trauma. Severe tenderness and limited mobility were observed in her left shoulder. On radiographic examination, a middle-third clavicle fracture was diagnosed. Ptosis and myosis were also noticed on further examination, and she was subsequently diagnosed with Horner's syndrome. A survey of the brain, cervical spine, carotid artery, and lung revealed no pathological findings. Surgery for the clavicle fracture was performed 2 days after the accident. The patient recovered from Horner's syndrome gradually over the 2 months following the surgery, and the syndrome completely resolved by the third month. To the best of our knowledge, this is the fi